Tempco Electrical Terminations

No Electrical Termination(s)

Electrical Terminations are not required in a Cool Only Maxiband.
If you want to add an Electrical Termination please change your Construction Style selection to Heat and Cool or Heat Only.

/Tempco/Data-Assets/01-Band-Images/WebF007.jpg

Type S: Terminal Lugs

Terminal Lugs with 10-32 binding head screws.

/Tempco/Data-Assets/01-Band-Images/WebF005.jpg

Type W3: Wire Braid Leads

Stainless Steel Wire Braid provides strength and protection to the lead wire’s insulation and offers sharp bending not possible with armor cable. The standard leads are 20″ of wire braid over 24″ of flexible leads.

/Tempco/Data-Assets/01-Band-Images/WebF002.jpg

Type R1: Armor Cable

Armor Cable provides excellent protection against abrasion and contaminants. The cable exits through an adapter that encapsulates both elements’ ends on each half. The adapter tube is tack welded to the heating element and the cable is crimped to the adapter for maximum security and seal protection. The standard leads are 20″ of cable over 24″ of flexible leads.

/Tempco/Data-Assets/01-Band-Images/WebF006.jpg

Type TS: Leads with Contamination Seal

Teflon® shrink-down sleeving provides good moisture and contamination seal. The maximum temperature allowed at the Teflon® seal sleeve is 500°F (260°C). The standard flexible leads are 24″ in length.

/Tempco/Data-Assets/01-Band-Images/WebB528.jpg

Type EP: Explosion and Moisture Resistant Box

Maxiband heaters can be made with an explosion/moisture-resistant box brazed onto the heater.

/Tempco/Data-Assets/01-Band-Images/WebF003SS.jpg

Type C3: General Purpose Terminal Box

Terminal Boxes provide a simple and economical way to eliminate all live exposed terminals and electrical wiring that can be a potential hazard. The boxes have a 1/2″ trade size knockout (actual diameter 7/8″) for standard connectors. The standard termination is Type S, Terminal Lugs. Heaters can be factory prewired with high-temperature lead wire, armor cable, or stainless steel wire braid.

/Tempco/Data-Assets/01-Band-Images/WebF004SS.jpg

Type P2: Quick Disconnect High-Temperature Plug

Quick Disconnect Plug assemblies are highly recommended to provide the simplest and safest way to apply power to band heater installations.

Plug Electrical Ratings 2-Pole 3-Wire Grounding
Maximum Amps: 16
Maximum Volts: 250 VAC
Maximum Temperature: 572°F (300°C)