Tri-Tronics Photocraft RS

PRODUCT DESCRIPTION

The model RS is a 2-1/4″ cube incremental encoder with four 6-32 x 1/4″ deep mounting holes on a 2″ diameter bolt circle located on both ends and the bottom. The enclosure is constructed of 1/8″ minimum thick aluminum with a connector and single or double ended shaft. This model is compatible with most cube style encoders on the market.

Shaft rotation is converted into square wave output pulses to provide an accurate means of digitizing position, rate or direction of rotation. Output pulses are generated when an internal code disk mounted on the shaft and having the specified output pattern is read by 1, 2, or 3 opto-sensors depending on the number of outputs required. The matched LED and opto-sensor pairs, compensation circuitry and rugged aluminum housing assure continuous, reliable operation in industrial environments.

Accessories and customized configurations are available including electrical functions such as direction of rotation indication, measuring wheels, special shafts, and flexible couplings.  The type of outputs are based on shaft rotation as follows:

Pulse Output: A Single output (A) with a specific number of counts per revolution (cpr) of the shaft; Dual outputs (A and B) with two independent outputs and the cpr on A can be different than the cpr on B; or Triple outputs (A, B, and C) with three independent outputs.

Quadrature: Two pulse outputs, A and B, have the same cpr and are in quadrature relation to each other (A leads B by 90
for clockwise rotation as viewed from shaft end farthest from connector). This will indicate distance and direction of shaft rotation to any control device that accepts quadrature inputs.

Zero Marker Output: Provides a zero reference or index pulse on output Z occurring once per revolution, having a pulse width approximately equal to a pulse on output A.

Direction Output: Indicates the direction of shaft rotation, clockwise or counter-clockwise.

Minimum Speed Output: Indicates when the shaft exceeds a predetermined revolutions per minute (rpm).

Anti-Jitter feature:  Designed for conveyor and web systems requiring continuous and accurate measurement of the web’s movement even if the system must be stopped and restarted without reset. When the web stops, and if there is sufficient vibration or back-and-forth movement, then the encoder output could oscillate, appearing as if the web were actually moving. Anti-jitter eliminates this condition by significantly increasing the pulse hysteresis.

INDUSTRY USE

PRODUCT DOCUMENTATION	ADDITIONAL INFORMATION
Datasheet Drawings	Shaft Options Output Types Counts per Revolution Options Anti-Jitter Option Supply Voltage Options Output Circuits

MODIFIED VERSIONS

Modification	Description
M80	Modified connector wiring, ECCI PU863, PU868 compatible see also M122	Datasheet
M88	Current sinking outputs with 1.5K pull-up resistors	Datasheet
M104	6mm shaft diameter	Datasheet
M111	Modified connector wiring	Datasheet
M122	Modified connector wiring, ECCI PU863, PU868 compatible see also M80	Datasheet
M131	Encoder with M12 4-pin connector	Datasheet
M139	Single output encoder with Enhanced Anti-Jitter feature	Datasheet
M143	RS encoder with a Mini-Con-X connector	Datasheet
M149	RS encoder with attached cable	Datasheet
M160	Modified connector wiring	Datasheet
M172	Modified connector wiring to match Red Lion model RPGB encoder	Datasheet
M173	Current sinking outputs with 2.2K pull-up resistors	Datasheet
M182	RS encoder with single ended shaft and heavy duty bearings	Datasheet
M184	RS with MB-FL6 adapter, heavy duty bearings, .86″ shaft length	Datasheet
M188	RS with 8-pin connector for +A/-A, +B/-B, +Z/-Z outputs	Datasheet