Tempco Electrical Terminations

/Tempco/Data-Assets/02-Cartridge-Images/WebC040.jpg

Type F: Flexible Leads

Standard termination for Square Cartridge Heaters. Leads are internally connected. Sharp bending of the lead wire is possible where it exits the heater. 3/16″ and 1/4″ heaters use Teflon® insulated wires. 3/8″, 1/2″ and 5/8″ heaters use 482°F (250°C) rated fiberglass insulated lead wires. 10″ leads are standard.

/Tempco/Data-Assets/02-Cartridge-Images/WebC039.jpg

Type W: Straight Braided Leads

Abrasion resistant while still allowing sharp bending that is not possible with armor cable. 10″ of stainless steel wire braid over 12″ leads is standard.

/Tempco/Data-Assets/02-Cartridge-Images/WebC036.jpg

Type W1: Right-Angle Braided Leads

Abrasion resistant while still allowing sharp bending that is not possible with armor cable. 10″ of stainless steel wire braid over 12″ leads is standard.

/Tempco/Data-Assets/02-Cartridge-Images/WebC035.jpg

Type C1: Straight Armor Cable

Abrasion resistant. 10″ of galvanized cable over 12″ leads is standard.

/Tempco/Data-Assets/02-Cartridge-Images/WebC037.jpg

Type C3: Right Angle Armor Cable

Abrasion resistant. 10″ of galvanized cable over 12″ leads is standard.

/Tempco/Data-Assets/02-Cartridge-Images/WebC035.jpg

Type S1: Straight Spring

Flex resistant 2-1/2″ long spring with 10″ leads standard.

/Tempco/Data-Assets/02-Cartridge-Images/WebC032.jpg

Type T3: Double-End Screw Terminal

Thread is 8-32 by 3/4″ long.